Photooxidation of anionic surfactant (sodium lauryl sulfate) in a three-phase fluidized bed reactor using TiO2/SiO2 photocatalyst

The photooxidation of sodium lauryl sulfate (=sodium dodecyl sulfate) in two different types of three-phase fluidized bed reactors was investigated. A low concentration of sodium lauryl sulfate (0.1–0.6 mM) in aqueous solution was photocatalytically decomposed by a TiO2 photocatalyst immobilized on a porous SiO2 support. In order to determine the optimum operating conditions in the fluidized beds, the effects of the air flow rate, amount of catalyst, initial concentration of surfactant, light source power, and pH on the photooxidation rate were investigated. From the experimental results, it was observed that the superficial air velocity was an important parameter in determining the reaction rate for both reactors. The photooxidation reaction rate increased with increasing UV lamp power and the experimentally obtained reaction rates showed good agreement with the Langmuir adsorption model. Also, a higher reaction rate was observed when the aqueous solution was acidic.