Effect of milling energy on the structural evolution and stability of nanostructured Al-5.7 wt.% Ni mechanically alloyed eutectic alloy

In the current research, mechanical alloying (MA) was employed to synthesize nanostructured Al-5.7wt.%Ni eutectic alloy through the variation of the milling parameters. Three-dimensional parametric phase diagrams were constructed for the alloy start and complete formation times over a range of ball-to-powder ratio (BPR), rotational speeds (RPM) and milling time (MT). Total energies of 224 kJkg− 1 and 1068 kJkg− 1 were necessary to trigger and complete the Al-5.7wt.%Ni eutectic alloy formation, respectively. X-ray diffraction (XRD) was employed to determine the eutectic alloy powders formation progress as a function of MT and for the investigation of the internal structural evolution in terms of crystallite sizes and lattice strain induced by milling. Prolonged milling up to 40 h of MT resulted in changes in the powder morphology and produced nanocrystalline (NC) alloy powders about 20 nm in average crystallite size. Isothermal heating (ITH) of the milled loose powders at 500 °C for 60 min using differential scanning calorimetry (DSC) was employed for the evaluation of the thermal stability produced NC structure. Alloys milled up to the alloy complete formation time at intermediate milling energies of 300 RPM and 15:1 BPR displayed relatively higher structural stability against grain growth compared to the powders milled at higher milling energies. Prolonged MT strongly influenced the morphology of the eutectic structure, which had a negative impact on the structural stability against growth during heating for both the as milled powders and the hot compact discs.

Nanostructured Al-5.7wt.% Ni eutectic alloy powders (18–26 nm) were synthesized via mechanical alloying (MA). Total milling energies of 224 and 1068 kJkg−1 were necessary to start and complete the alloy formation. Three-dimensional parametric diagrams for the alloy start and complete formation were constructed. Complete formation milling energies produced alloyed powders and consolidates with enhanced structural stability compared to higher milling energies.Figure optionsDownload as PowerPoint slideHighlights
► Nanostructured Al-5.7 wt.% Ni eutectic alloy powders (18–26 nm) were synthesized via MA.
► Total milling energy of 224 and 1068 kJkg− 1 were necessary to start and complete the alloy formation.
► 3-dimensional parametric diagrams for the alloy start and complete formation were constructed.
► Prolonged milling up to 40 h segregates and clusters Al3Ni dispersoids within the α-Al matrices.
► Alloy powders milled at 15:1 BPR, 300 RPM for 21 h exhibit relatively higher structural stability.