کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
238555 | 465763 | 2009 | 6 صفحه PDF | دانلود رایگان |
Preparation of hydroxyapatite microspheres by spray drying technology at different process parameters was investigated in this paper. The results indicated that the process parameters, such as the slurry concentration, compressed air flow rate, and liquid feed rate, played important roles in controlling the performance of hydroxyapatite microspheres, such as the specific surface area, the size distribution, etc., but had little influence on the micromorphology, phase composition and crystallinity. The spray dried particles were composed of low crystallinity and the scanning electron microscope results showed that they had good spherical structure with smooth surface. The results of the laser diffraction particle size analyzer indicated that the mean size increased with the increase of the slurry concentration and compressed air flow rate. Experimentally, most of the process parameters were crucial to the productive efficiency.
Preparation of hydroxyapatite microspheres by spray drying technology at different process parameters was investigated. The spray dried particles were composed of low crystallinity and had good spherical structure with smooth surface. The mean size increased with the increase of the slurry concentration and compressed air flow rate. Most of the process parameters were crucial to the productive efficiency.Figure optionsDownload as PowerPoint slide
Journal: Powder Technology - Volume 191, Issues 1–2, 4 April 2009, Pages 1–6