A model for initial-stage sintering thermodynamics of an alumina powder

A model was proposed to calculate several thermodynamic parameters for the initial-stage sintering of an alumina powder obtained after calcinations at 900 °C for 2 h of a precursor. The precursor was synthesized by an alumina sulphate–excess urea reaction in boiling aqueous solution. The cylindrical compacts of the powder with a diameter of 14 mm were prepared under 32 MPa by uniaxial pressing using oleic acid (12% by mass) as binder. The compacts were fired at various temperatures between 900 and 1400 °C for 2 h. The diameter (D) of the compacts before and after firing was measured by a micrometer. The D value after firing was taken as a sintering equilibrium parameter. An arbitrary sintering equilibrium constant (Ka) was calculated for each firing temperature by assuming Ka = (Di − D) / (D − Df), where Di is the largest value before sintering and Df is the smallest value after firing at 1400 °C. Also, an arbitrary change in Gibbs energy (ΔG a°) was calculated for each temperature using the Ka value. The graphs of ln Kavs. 1 / T and ΔG a° vs. T were plotted, and the real change in enthalpy (ΔH°) and the real change in entropy (ΔS°) were calculated from the slopes of the obtained straight lines, respectively. Inversely, real ΔG° and K values were calculated using the real ΔH° and ΔS° values in the ΔG° = − RT ln K = ΔH° − TΔS° relation. The best fitting ΔH° and ΔS° values satisfying this relation were found to be 157,301 J mol− 1 and 107.6 J K− 1 mol− 1, respectively.

A model was proposed to calculate some thermodynamic parameters for the initial stage sintering of an alumina powder. The alumina compacts were fired at various temperatures between 900 and 1400 °C for 2 h. The diameter (D) of compacts after firing was taken as a sintering equilibrium parameter. An arbitrary sintering equilibrium constant (Ka) was calculated for each firing temperature by assuming Ka = (Di − D) / (D − Df), where Di is the largest value before sintering and Df is the smallest value after firing at 1400 °C. The relations between thermodynamic parameters are found as follows: ∆G° = − RT ln K = ∆H° − T∆S° = 157,301 − 107.6TFigure optionsDownload as PowerPoint slide