Manufacture and optimization of tubular ceramic membrane supports

The manufacturing and optimization of centrifugally casted ceramic membrane supports is presented. For the optimization, the effect of three different powder sizes (0.25, 0.31 and 0.61 μm) and a sintering temperature range between 1050 and 1400 °C was investigated. The ceramic tubes were characterized according to tube dimensions, mercury porosimetry, water permeability, SEM and mechanical strength. It was shown that the centrifugal casting technique delivers highly reproducible support properties. A novel strength testing apparatus was developed to determine the mechanical strength of the ceramic tubes. It was found that the strength varied between 3300 MPa and 300 MPa, depending on the porosity of the supports. With increased sintering temperature, water permeability and porosity decreased, while strength and linear shrinkage increased. The pore diameter of the supports produced by the 0.31 and 0.61 μm powders decreased, while that of the 0.25 μm powders remained constant (72 nm) with increasing sintering temperature. The 0.61 μm powder sintered at the lowest sintering temperature resulted in the support with the highest porosity, pore diameter and porosity, but the lowest mechanical strength and linear shrinkage. An overall improvement concerning pure water permeability was seen when the support in this study was compared to our own previous studies and similar studies in literature.

Three particle sizes sintered at temperature between 1050 and 1400 °C were investigated. Characterization according to dimensions of the tube, mercury porosimetry, water permeability, SEM and strength were performed. A decrease in water permeability and porosity with increasing sintering temperature was observed, while there was an increase in strength and linear shrinkage. Water permeability values larger than previous literature studies were obtained.Figure optionsDownload as PowerPoint slide