Velocity measurements and flow field characteristic analyses in a turbo air classifier

Turbo air classifier is one of the most widely used powder classification equipment. The rotor cage as a rotary component can create a forced centrifugal field, so it is a key part for turbo air classifier. In order to investigate the effect of structural variations of the rotor cage on flow field characteristics, three dimensional velocity measurements of the annular region in a turbo air classifier equipped with two different rotor cage bottom plates (A and B type) are performed by laser Doppler velocimeter (LDV). It is found that the different bottom plates have different axial and tangential velocity distributions in the annular region. However, the structural variations of the rotor cage have hardly any effect on the radial velocity. Based on the classification principle, the relation between the classification performance and the flow field characteristics is investigated in great detail.The results of the flow field measurements were tested by the classification experiments carried out with cement raw meal and ground calcium carbonate. The results demonstrate that B type bottom plate can realize the production of narrow particle size distributions, so it is more favorable for classification than A type bottom plate. Classification experiment results are in good agreement with the results of the flow field measurements.

Velocity measurement of the annular region in a turbo air classifier is performed by Laser Doppler Velocimeter (LDV). The influence of the different rotor cage structures (A and B type bottom plates of the rotor cage) on flow field characteristics was investigated. The contrastive experiments of the material classification are in good agreement with flow measurement result.Figure optionsDownload as PowerPoint slide