کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
239159 | 465801 | 2007 | 8 صفحه PDF | دانلود رایگان |
The effect of energy input, pH and temperature on de-aggregation of hydrophilic silicon dioxide powder (particle size 12 nm) in a high shear mixer was investigated. It has been found that de-aggregation is a two step process. Initially, at low energy input very large aggregates (3–1000 μm) are gradually broken into smaller secondary aggregates (2–100 μm) of a single modal size distributions. As the energy input increases primary aggregates (0.03–1 μm) are eroded from the secondary aggregates leading to bimodal size distributions with the first mode between 0.03 μm and 1 μm corresponding to the primary aggregates and the second mode between 2 μm and 100 μm corresponding to the secondary aggregates. At a sufficiently high energy density all secondary aggregates are broken into primary aggregates however, even at the highest energy density employed the primary aggregates could not be broken into single nano-particles. The temperature and the pH affect de-aggregation kinetics but do not alter de-aggregation pattern. Increasing pH at low temperature speeds up de-aggregation, whilst increasing pH at high temperature slows down de-aggregation process.
De-aggregation of hydrophilic silicon dioxide nano-powder (12 nm particle size) is a two step process. Initially, very large aggregates are broken into smaller secondary aggregates of a single modal size distribution (0 min curve in Fig. 1). As the energy input increases primary aggregates are eroded from the secondary leading to bimodal size distributions (50 min curve in Fig. 1). At a sufficiently high energy density all secondary aggregates are broken into primary aggregates (240 min curve) however, even at the highest energy density employed the primary aggregates could not be broken into single nano-particles.Figure optionsDownload as PowerPoint slide
Journal: Powder Technology - Volume 173, Issue 3, 30 April 2007, Pages 203–210