کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
255014 | 503343 | 2012 | 14 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Consolidation behavior of soil–cement column improved ground Consolidation behavior of soil–cement column improved ground](/preview/png/255014.png)
Columnar inclusion is one of the effective and widely used methods for improving the engineering properties of soft clay ground. This article investigates the consolidation behavior of composite soft clay ground using both physical model tests under an axial-symmetry condition and finite element simulations using the PLAXIS 2D program. It was determined that the final settlement and the rate of consolidation of the composite ground depended on the stress state. For an applied stress that is much lower than the failure stress, the final settlement of the composite ground was lower, and the consolidation was rapid. When the soil–cement column failed, the stress on the column suddenly decreased (due to strain-softening); meanwhile, the stress on the soil increased to maintain the force equilibrium. Consequently, the excess pore pressure in the surrounding clay increased immediately. The cracked soil–cement column acted as a drain, which accelerated the dissipation of the excess pore pressure. The consolidation of the composite ground was mainly observed in the vertical direction and was controlled by the area ratio, which is the ratio of the diameter of the soil–cement column to the diameter of the composite ground, a. The stress on the column was shown to be low for a composite ground with a high value of a, which resulted in less settlement and fast consolidation. For a long soil–cement column, the excess pore pressures in the surrounding clay and the column were essentially the same at a given consolidation time throughout the improvement depth. It is proposed that the soil–cement column and surrounding clay form a compressible ground, and the consolidation occurs in the vertical direction. The composite coefficient of consolidation (cv(com)) that was obtained from the physical model test on the composite ground can be used to approximate the rate of consolidation. This approximation was validated via a finite element simulation. The proposed method is highly useful to geotechnical engineers because of its simplicity and reliable prediction.
Journal: Computers and Geotechnics - Volume 43, June 2012, Pages 37–50