Numerical analysis on post-grouted drilled shafts: A case study at the Brazo River Bridge, TX

This paper investigates the effects of post-grouting on the behavior of drilled shafts using a case study carried out at the Brazo River, Texas. Commercial finite element software, PLAXIS, was used to quantify the improvement of the tip resistance and side shear resistance of post-grouted drilled shafts (PGDS). The input material parameters of PLAXIS were initially estimated using CPT sounding results, and then the parameters were updated by calibrating the numerical results against full-scale STATNAMIC load test results. Based on the numerical analysis, the authors concluded that (1) the increase in total resistance of PGDS resulted from soil improvement at the shaft tip, (2) the apparent increase in side shear resistance resulted from side shear reversal that occurred during post-grouting, and (3) the apparent increase in the tip resistance of PGDS may be caused by stress relief of the grout. In addition, two approaches to estimate the resistance of PGDS were compared against numerical results. In this case study, the Axial Capacity Multiplier (ACM) approach over-predicted the total resistance whereas the Tip Capacity Multiplier (TCM) approach reasonably predicted the increase in total resistance.