Experimental procedures for testing the performance of rail dampers

Rail dampers work by increasing the attenuation with distance of vibration transmitted along the rail, a quantity known as the track decay rate. Currently, there are no standardized procedures to measure their effectiveness in reducing rolling noise without the need for in-track installation and time-consuming tests. This paper describes and evaluates experimental procedures for assessing rail dampers. Instead of field measurements it is proposed to use laboratory measurements of vertical and lateral decay rates on a free rail equipped with dampers. These are combined with in-situ measurements on an undamped track. The decay rates of a damped track can be approximated by adding the results of the damped free rail to those of the undamped track.Three different methods are studied to measure the decay rates of damped free rails: (i) using a long rail, in the present work 32 m long, from frequency response functions measured at intervals along the rail; (ii) using a short rail, in the present work 6 m long, from the modal properties of the rail; and (iii) directly from the point and transfer frequency response functions at both ends of the short rail. The latter two are complementary: the modal method is more suited to low frequencies while the direct method is more suited to high frequencies. These methods are evaluated theoretically and by comparison with experimental results.Good agreement is found between the various methods, for vibration in both vertical and lateral directions, between 300 Hz and 5 kHz. In practice, the direct short-rail method is likely to be sufficient for most applications. The limitations of the methods are identified and corrections are proposed for the effect of near-field waves in the rail.