Numerical investigation of longitudinally stiffened web channels predominantly in shear

• Shear tests of cold-formed channels with longitudinal web stiffeners are summarised.
• Finite Element Method (FEM) modelling is validated against the tests.
• The range of test data is extended using the FEM.
• The tests and FEM results are compared with the Direct Strength Method (DSM) of design.

In practice, there is a wide variety of commercially available channel sections with complex shapes where the web is stiffened by adding longitudinal intermediate stiffeners. These stiffeners may improve the shear capacity of the channels. Recently, the Direct Strength Method (DSM) of design of cold-formed sections has been extended in the North American Specification for Cold-Formed Steel Structural Members (NAS S100:2012) to include shear based on research by the authors. The prequalified sections include flat webs and webs with small intermediate longitudinal stiffeners. To extend the range to larger intermediate stiffeners as occurs in practice, a series of predominantly shear tests of lipped channel sections with one web stiffener of different shapes and various sizes has been performed at the University of Sydney. Six different types of stiffened web channel sections were tested along with an additional reference plain section. All tests were conducted with straps screwed on the top flanges adjacent to the loading points. These straps provide torsion/distortion restraints which may enhance the shear capacities of the sections. The test failures were observed mainly in the combined bending and shear modes. Numerical simulations based on the Finite Element Method (FEM) using the software package ABAQUS/Standard are also performed to compare with and calibrate against the tests. The accurate results from the FEM models allow extension of the test data. Based on the reliable FEM models, a series of FEM modelling of predominantly shear tests for stiffened web channels has been performed without straps attached to the top flanges adjacent to loading points. The test and FEM results are subsequently plotted against the DSM interaction curves between bending and shear where the interaction is found to be significant. An extended range of DSM prequalified sections with longitudinally stiffened web channels in shear is proposed in this paper.