Experimental study of contouring accuracy for CNC machines executing curved paths with constant and curvature-dependent feedrates

Experiments to measure and improve the contouring accuracy of CNC machines executing curved paths with strong curvature and variations of curvature at high feedrates are reported, using P and PI controllers with a wide range of gains. The experiments are based on test curves exhibiting (a) a steady increase of curvature; (b) a periodic curvature variation between fixed minima and maxima; and (c) a sudden “spike” in the curvature profile. For the P controller, the curvature-dependent feedrate yields a diminution of the contour error by up to an order of magnitude, compared to constant feedrate. The curvature-dependent feedrate appears to be most advantageous in situations exemplified by case (c), since it affords a dramatic suppression of local contour error with a modest increase in traversal time. Moreover, the improvement in contour accuracy is relatively insensitive to the P gain. The results are less predictable when the curvature-dependent feedrate is used in conjunction with PI control, because of its more “active” response to the excitation arising from the varying path geometry and feedrate.

► Experiments demonstrate improvements in contouring accuracy of CNC machines through use of curvature-dependent feedrates.
► Contour error reduced by an order of magnitude with P control.
► Most advantageous for paths with “spikes” in curvature profile.
► With curvature-dependent feedrate, P controller usually gives better contouring accuracy than PI controller.