کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
4986450 | 1454947 | 2017 | 7 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Insights into the sliding wear behavior of a copper-steel pair with oils containing extreme-pressure additives
ترجمه فارسی عنوان
نگاهی به رفتار سایش کششی یک جفت مس-فولاد با روغن های حاوی افزودنی های شدید فشار
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
رفتار سایش کشویی، جفت مس-فولاد، فیلم تریبو، لباس اکسیداتیو،
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی شیمی
شیمی کلوئیدی و سطحی
چکیده انگلیسی
Under four typical lubricating conditions, viz.,(i) no lubrication, and lubrication with a (ii) base oil, (iii) base oil with a single extreme-pressure (EP) additive, and (iv) base oil with composite EP additives, a custom-made tribo-tester with steel on a copper ring was used to understand the friction and wear behavior of the copper-steel pair. Surface morphologies of friction-pairs were observed by scanning electron microscopy (SEM). The composition of the surface residues was analyzed using an energy dispersive spectrometer (EDS) and an X-Ray photoelectron spectrometer (XPS). The results showed three forms of wear on the copper surface in the wear process when the copper-steel pair was lubricated with base oil containing composite EP additives. During the first 500â2500Â s, adhesive wear appeared and then transformed into a plowing wear. After 2500Â s, oxidative wear in certain regions was the major force, with a concomitant drop in the relative wear rate to a value as low as 22.5%. Compared to lubrication with base oil, that with base oil containing composite EP additives significantly reduced the friction coefficient between the copper/steel pairs, with the plowings being shallow, and the morphology of the copper surface much improved. Two kinds of adsorption layers were formed on the steel surface and they played an important role in anti-wear and friction-reducing during the entire process. One is a chemical reaction layer consisting of Cu2O, CuFeS2, and FePO4 generated from the reaction of the active elements P or S with copper/iron during sliding wear, while the other is a physical adsorption layer containing decomposed borate oxides, Fe and Cu on the steel surface.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Wear - Volumes 386â387, 15 September 2017, Pages 211-217
Journal: Wear - Volumes 386â387, 15 September 2017, Pages 211-217
نویسندگان
X.D. Yan, J.L. Sun, S. Xiong, Y.Q. Hou,