Adhesive joints in glass structures: effects of various materials in the connection, thickness of the adhesive layer, and ageing

This paper reports on an investigation of glued joints in glass load-bearing structures, with reference to the effect of various substrates (glass, steel, stainless steel, aluminium) and their surface treatment (sandblasting for the glass surface) on the adhesion of selected adhesives. The thickness of the adhesive layer and the effect of artificial ageing - a simulation of 5 years of ageing in outdoor central-European conditions - are also discussed. Tensile and shear tests were carried out on three series of specimens with various adhesives and substrates - two series for tensile and shear tests, and one series for shear tests on specimens exposed to ageing. Our results show that sandblasting the glass surface can improve the adhesion, and thus the strength values, of an adhesive joint in cases where, with a smooth glass surface, cohesive failure is not reached. The thickness of the adhesive layer had a significant effect for a semi-rigid acrylate adhesive, where the joint achieved higher strength values with less thickness of the glue. The effect of ageing varied according to the adhesive. The most visible changes were observed for a two-component acrylate adhesive and for methacrylate UV-adhesives. One of the selected glues was marked as unsuitable for load-bearing connections due to significant worsening of its mechanical properties after ageing.