کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
610429 880648 2009 6 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Preparation and characterization of layer-by-layer self-assembled polyelectrolyte multilayer films doped with surface-capped SiO2 nanoparticles
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی شیمی کلوئیدی و سطحی
پیش نمایش صفحه اول مقاله
Preparation and characterization of layer-by-layer self-assembled polyelectrolyte multilayer films doped with surface-capped SiO2 nanoparticles
چکیده انگلیسی

SiO2 nanoparticles capped with γ-aminopropyltrimethoxysilane were doped into polyelectrolyte (poly(allylamine hydrochloride), PAH, and poly(acrylic acid), PAA) multilayer films via spin-assisted layer-by-layer self-assembly. The resulting as-prepared multilayer films were heated at a proper temperature to generate cross-linked composite films with increased adhesion to substrates. The tribological behavior of the multilayer films was evaluated on a microtribometer. It was found that SiO2-doped composite films had better wear resistance than pure polyelectrolyte multilayers, possibly because doped SiO2 nanoparticles were capable of enhancing load-carrying capacity and had “miniature ball bearings” effect. Moreover, heat-treatment had significant effect on the morphology of the composite films. Namely, heat-treated (SiO2/PAA)9 film had a larger roughness than the as-prepared one, due to heat-treatment-induced agglomeration of SiO2 nanoparticles and initiation of defects. However, heat-treated (PAH/PAA)3/(SiO2/PAA)3(PAH/PAA)3 film had greatly reduced roughness than the as-prepared one, and it showed considerably improved wear resistance as well. This could be closely related to the “sandwich-like” structure of the composite multilayer film. Namely, the outermost strata of composite multilayer film were able to eliminate defects associated with the middle strata, allowing nanoparticles therein to maintain strength and robustness while keeping soft and fluid-like exposed surface. And the inner strata were well anchored to substrate and acted as an initial “bed” for SiO2 nanoparticles to be inhabited, resulting in good antiwear ability.

The tribological behavior of three films was studied, which could be related to the structures of the films. Furthermore, the introduction of SiO2 nanoparticles helped to increase the tribological behavior.Figure optionsDownload as PowerPoint slide

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Colloid and Interface Science - Volume 333, Issue 2, 15 May 2009, Pages 776–781
نویسندگان
, , , ,