Encapsulation of emitting CdTe QDs within silica beads to retain initial photoluminescence efficiency

Highly luminescent silica beads (30 nm–2 μm ∅) incorporating CdTe quantum dots (QDs) were prepared via a two-step preparation procedure, namely a modified Stöber synthesis and a subsequent reverse micelle route. In the modified Stöber synthesis, the silica molecules are deposited on the surface of the QDs. After this first step, these coated QDs were incorporated into silica beads via a reverse micelle route. Inductively coupled plasma analysis revealed a red-emitting silica bead of 30 nm in diameter thus prepared encapsulated roughly 14 CdTe QDs. These glass beads (30–40 nm ∅) retained the initial photoluminescence (PL) efficiencies of the colloidal QDs (27 and 65% for the green- and red-emitting beads, respectively). The protection of QDs by a silica layer at the first step, together with the short total reaction time, is the main reason for the retention of the PL efficiency. The size of the glass beads can be easily controlled over the wide range by adjusting the injection speed and the ratio of chemicals used for the reverse micelle preparation. Since the original efficiency was maintained in the beads and is the highest ever reported for QD-containing silica beads, the method presented here is of significant importance for applications of silica beads to biological probes.

SiO2 beads incorporating emitting CdTe QDS revealed high PL efficiency (65%) via a two-step synthesis. The high PL efficiency of the beads opens up new possibilities for various applications.Figure optionsDownload as PowerPoint slide