New methodology to determine the rate-limiting adsorption kinetics mechanism from experimental dynamic surface tension data

We present a new methodology to determine the rate-limiting adsorption kinetics mechanism (diffusion-controlled vs mixed diffusion-barrier controlled), including deducing the kinetics parameters (the diffusion coefficient, D, and the energy-barrier parameter, β), from the experimental short-time dynamic surface tension (DST) data. The new methodology has the following advantages over the existing procedure used to analyze the experimental DST data: (a) it does not require using a model for the equilibrium adsorption isotherm, and (b) it only requires using the experimental short-time DST data measured at two initial surfactant bulk solution concentrations. We apply the new methodology to analyze the experimental short-time DST data of the following alkyl poly(ethylene oxide), CiEj, nonionic surfactants: C12E4, C12E6, C12E8, and C10E8 measured using the pendant-bubble apparatus. We find that for C12E4 and C12E6, the effect of the energy barrier on the overall rate of surfactant adsorption can be neglected for surfactant bulk solution concentrations below their respective critical micelle concentrations (CMCs), and therefore, that the rate-limiting adsorption kinetics mechanism for C12E4 and C12E6 is diffusion-controlled at any of their premicellar surfactant bulk solution concentrations. On the other hand, for C12E8 and C10E8, we find that their respective CMC values are large enough to observe a significant effect of the energy barrier on the overall rate of surfactant adsorption. In other words, for C12E8 and C10E8, the rate-limiting adsorption kinetics mechanism shifts from diffusion-controlled to mixed diffusion-barrier controlled as their premicellar surfactant bulk solution concentrations increase. We test the new methodology by predicting the short-time DST profiles at other initial surfactant bulk solution concentrations, and then comparing the predicted DST profiles with those measured experimentally. Very good agreement is obtained for the four CiEj nonionic surfactants considered. We also compare the results of implementing the new methodology with those of implementing the existing procedure, and conclude that using a model for the equilibrium adsorption isotherm can lead not only to different values of D and β, but it can also lead to a completely different determination of the rate-limiting adsorption kinetics mechanism. Since the new methodology proposed here does not require using a model for the equilibrium adsorption isotherm, we conclude that it should provide a more reliable determination of the rate-limiting adsorption kinetics mechanism, including the deduced kinetics parameters, D and β.

A new methodology to obtain adsorption kinetics information solely from experimental dynamic surface tension data without using any equilibrium adsorption isotherm model.Figure optionsDownload as PowerPoint slide