Dry three-body abrasive wear behavior of WC reinforced iron matrix surface composites produced by V-EPC infiltration casting process

This paper fabricated tungsten carbide (WC) particles reinforced iron matrix surface composites on gray cast iron substrate using vacuum evaporative pattern casting (V-EPC) infiltration process, investigated dry three-body abrasive wear resistance of the composites containing different volume fractions of WC particles, comparing with a high chromium cast iron. The fabricated composites contained WC particles of 5, 10, 19, 27, 36, and 52 vol.%, respectively. The results in abrasive wear tests showed that, with the increase in the volume fraction of WC particles, the wear resistance of the composites first increased until reached the maximum when the volume fraction of WC was 27%, then decreased, and was 1.5–5.2 times higher than that of the high chromium cast iron. The changes of the wear resistance of the composites with the volume fraction of WC particles and the mode of material removal in dry three-body abrasive wear condition were analyzed.