Reverse roll coating with a deformable roll operating at negative gaps

- The paper revisits the well-established reverse roll coating but using a deformable metering roller.
- This “new” development provides a simple technique to produce very thin films, down to 1 µm at speeds up to 150 m/min.
- The data are underpinned by simple lubrication modelling.

Reverse roll coating is probably the most widely used coating operation, yet its full potential has not been exploited as it is shown in this paper which considers operation with a negative gap. We demonstrate through a wide range of experimental data that such operation can yield very thin and stable films with no ribbing or cascade instabilities when low viscosity fluids are used. Typically, stable film thickness less than 5 μm can be obtained at speeds up to 150 m/min when a rubber roller is used at −100 μm gap with fluids of viscosity in the range 10-200 mPa s. These film thicknesses can be made to decrease further down to 1 or 2 µm with a judicious choice of speed ratios (applicator to metering roller) and rubber hardness. Such new findings make this simple coating method an attractive roll to roll technique for application in the newer coating technologies, such as in the production of solar cells and plastic electronics. The data obtained in this study have been underpinned by a model based on the classical lubrication theory, well developed for such flow situations. Essentially it is shown that the film thickness non dimensionalised with respect to the set negative gap is controlled through a single parameter, the elasticity number Ne which combines all the operating parameters. Of course, this flow problem has complexities, particularly at high speed ratios and at zero gap so the data obtained here can serve as a basis for more comprehensive modelling of this classical fluid mechanic problem.

90