Numerical simulation for the design analysis of kinematic Stirling engines

The mentioned analysis was applied for the study of an engine prototype that presented very low experimental performance. The numerical methodology was selected for the identification of possible causes that limited the performance. This analysis is based on a second order Stirling engine model that was previously developed and validated. The simulation allowed to evaluate the effect that different design and operational parameters have on the engine performance, and consequently different performance curves were obtained. These curves allowed to identify ranges for the charged pressure, temperature ratio, heat exchangers dimensions, crank phase angle and crank mechanical effectiveness, where the engine performance was improved. In addition, the curves also permitted to recognise ranges were the design parameters could drastically reduce the brake power and efficiency. The results also showed that the design of the engine is affected by the conditions imposed by the CHP interactions, and that the engine could reach a brake power closer to 832 W with a corresponding brake efficiency of 26% when the adequate design parameters were considered. On the other hand, the performance could also be very low; as the reported in experimental tests, with brake power measurements ranging 52-120 W.