کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
6753408 1430811 2018 19 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
An analytical study of the free and forced vibration response of a ribbed plate with free boundary conditions
ترجمه فارسی عنوان
یک مطالعه تحلیلی از پاسخ ارتعاش آزاد و اجباری یک ورق رشته با شرایط مرزی رایگان
کلمات کلیدی
لرزش، ورق براق شرایط مرزی رایگان تبدیل یکپارچه، طبقه بندی حالت حالت،
ترجمه چکیده
یک مطالعه تحلیلی برای پیش بینی پاسخ ارتعاش یک ورق رشته ای با شرایط مرزی آزاد ارائه شده است. راه حل تحلیلی با استفاده از یک روش تبدیل یکپارچه دوسویه به دست آمده و سپس برای بررسی ارتعاش آزاد و اجباری ورق ریزه شده و همچنین تاثیر رینگ در پاسخ مدال بشقاب یکنواخت مورد استفاده قرار گرفت. نشان داده شده است که علاوه بر سه حالت بسامد سخت افزاری صفر صفحات، حالت ارتعاش صفحات یکنواخت را می توان بر اساس خواص متقارن بشقاب با توجه به دو خط راست وسط به صورت موازی به لبه های صفحه چهار گروه حالت به دو گروه متقارن، یک گروه دو طرفه متقارن و دو گروه متقارن / ضد متقارن متصل می شوند. در حالی که گنجاندن رینگ به صفحه نشان می دهد که موجب تحریف در توزیع حالت ارتعاش می شود، اکثر حالت ها هنوز هم می توانند به حالت اصلی صفحات یکنواخت ردیابی شوند. هر دو جرم و سختی رباط بر روی ارتعاش مودال بشقاب یکنواخت تأثیر می گذارند، که در نتیجه اثر غالب آن از توده ی باند منجر به کاهش فرکانس مودال بشقاب می شود، در حالی که یک اثر غالب از سفتی ران به افزایش بار فرکانس صفحه هنگامی که رشته سفت شده به عنوان یک مرز موثر در ارتعاش صفحه رفتار می کند، یک صفحه اصلی صفحه به یک جفت حالت های منحرف تبدیل می شود، بدین ترتیب یک حالت دارای فرکانس بالایی است و حالت دیگر فرکانس پایین تر از حالت اصلی است.
موضوعات مرتبط
مهندسی و علوم پایه سایر رشته های مهندسی مهندسی عمران و سازه
چکیده انگلیسی
An analytical study to predict the vibration response of a ribbed plate with free boundary conditions is presented. The analytical solution was derived using a double cosine integral transform technique and then utilized to study the free and forced vibration of the ribbed plate, as well as the effect of the rib on the modal response of the uniform plate. It is shown that in addition to the three zero-frequency rigid body modes of the plate, the vibration modes of the uniform plate can be classified into four mode groups according to the symmetric properties of the plate with respect to the two orthogonal middle lines parallel to the plate edges. The four mode groups correspond to a double symmetric group, a double anti-symmetric group and two symmetric/anti-symmetric groups. Whilst the inclusion of the rib to the plate is shown to cause distortion to the distribution of vibration modes, most modes can still be traced back to the original modes of the uniform plate. Both the mass and stiffness of the rib are shown to affect the modal vibration of the uniform plate, whereby a dominant effect from the rib mass leads to a decrease in the modal frequency of the plate, whereas a dominant effect from the rib stiffness leads to an increase in plate modal frequency. When the stiffened rib behaves as an effective boundary to the plate vibration, an original plate mode becomes a pair of degenerate modes, whereby one mode has a higher frequency and the other mode has a lower frequency than that of the original mode.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Journal of Sound and Vibration - Volume 422, 26 May 2018, Pages 15-33
نویسندگان
, ,