Heat transfer and bubble dynamics in a three-phase inverse fluidized bed

In this study, surface-to-bed heat transfer experiments were performed to gain insight on heat transfer and hydrodynamics in a three-phase inverse fluidized bed. Air, tap water or 0.5 wt.% aqueous ethanol, and polypropylene were, respectively, the gas, liquid and solid phases. The solid loading was varied from 0 to 30 vol.%, and the gas and liquid superficial velocities from 2 to 50 mm/s and 0 to 21 mm/s, respectively. Visual observations were associated with measured phase holdups and instantaneous heat transfer coefficients. Larger gas velocities lead to an increase in bubble size due to the transition to the coalesced bubble flow regime. The greater turbulence induced by the larger bubbles increases the average heat transfer coefficient. On the other hand, adding ethanol reduces the heat transfer coefficient. Solid concentrations up to ∼13 vol.% increase the average heat transfer coefficient whereas higher solid concentrations tend to lower it. The distribution of instantaneous heat transfer coefficient peak height is wider at higher gas and liquid velocities while the addition of a surfactant narrows it. Gas holdups and average heat transfer coefficients are both compared with existing correlations, which are then adjusted for a better fit.