کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
688016 | 1460082 | 2015 | 9 صفحه PDF | دانلود رایگان |
• Flow distribution in a Z-type ladder network with 10 mini-channels is studied.
• A stairway shape and a tapered shape distributor/collector are tested and compared.
• Uniform flow distribution may be reached under very low flow-rate conditions.
• Larger inclined angle or fewer channels are favorable for more uniform distribution.
Parallel micro or mini-channels are widely used in various devices of process and energy engineering including micro-reactors, compact heat exchangers and fuel cells. Nevertheless, the flow maldistribution due to the improper design of distributor/collector is usually observed, leading to globally poor performances of these devices. The objective of this study is to optimize the shape of the distributor/collector pipes so as to achieve a uniform flow distribution among an array of parallel mini-channels. A Z-type ladder fluid network with 10 mini-channels in parallel having square section is introduced and investigated. Two methods are used to optimize the shape of distributor/collector pipes: an optimized discrete stairway shape and a continuous tapered shape with an inclined angle varying from 0° to 30°. 3D-CFD simulations are carried out using the ANSYS FLUENT code. Numerical results obtained show that a relatively uniform flow distribution may be reached by the discrete stairway shape or by the continuous tapered shape distributor/collector under very low flow-rate conditions. Larger inclined angle or fewer channels in parallel are favorable for more uniform flow distribution under higher flow-rate conditions. Nevertheless the distributor and the collector pipes occupy a large volume so that the entire device is less compact.
Figure optionsDownload as PowerPoint slide
Journal: Chemical Engineering and Processing: Process Intensification - Volume 95, September 2015, Pages 63–71