کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
7053439 1457606 2018 15 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
On the simulation of thick non-neutral boundary layers for urban studies in a wind tunnel
ترجمه فارسی عنوان
در شبیه سازی لایه های مرزی ضخیم غیر بی طرف برای مطالعات شهری در یک تونل باد
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی جریان سیال و فرایندهای انتقال
چکیده انگلیسی
Stable and convective boundary layers over a very rough surface have been studied in a thermally-stratified wind tunnel. Artificial thickening by means of spires was used to accelerate the formation of a sufficiently deep boundary layer, suitable for urban-like boundary layer flow and dispersion studies. For the stable boundary layer, the methodology presented in Hancock and Hayden (2018) for low-roughness offshore surface conditions has been successfully applied to cases with higher-roughness. Different levels of stratification and roughness produced modifications in the turbulence profiles of the lower half of the boundary layer, but little or no change in the region above. Data for a stronger stability case suggested that the employed spires may not be suitable to simulate such extreme condition, though further studies are needed. The results were in reasonably good agreement with field measurements. For the convective boundary layer, great attention was given to the flow uniformity inside the test section. The selection of a non-uniform inlet temperature profile was in this case found not as determinant as for the stable boundary layer to improve the longitudinal uniformity, while the application of a calibrated capping inversion considerably improved the lateral uniformity. The non-dimensional vertical profiles of turbulent quantities and heat fluxes, did not seem to be influenced by roughness.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Heat and Fluid Flow - Volume 72, August 2018, Pages 37-51
نویسندگان
, , ,