Pore-scale visualization of gas trapping in porous media by X-ray CT scanning

Entrapment of the non-wetting phase in porous media has been observed in a variety of fields such as petroleum engineering, geological storage of carbon dioxide, and remediation of ground water. We investigated gas trapping in porous media from a microscopic point of view. High-resolution, three-dimensional images of pore structure and trapped gas bubbles in Berea sandstones were obtained using a micro-focused X-ray CT scanner. We used vertical and horizontal Berea sandstone cores, 8 mm in diameter and 15 mm long. Based on the three-dimensional image analysis, the statistical distribution of the trapped gas volume was estimated. Trapped bubbles have a pore-network scale size and distribute over several pores. In the case of the vertical core, the porosity fluctuates along the flow direction due to the layered structure. The residual gas saturation also fluctuates with porosity along the flow direction. The higher gas saturation in porous layers at the end of gas injection results in a higher trapped gas saturation compared to dense layers. On the other hand, in dense layers the gas saturation at the end of gas injection is almost the same as residual gas saturation. Therefore, most of the gas injected into the dense layers would be trapped. In the case of the horizontal core, the gas saturation at the irreducible water condition is lower than that for the vertical core, because the injected gas selectively passes through the more permeable layers. However, the residual gas saturation is 29.2% for the horizontal core, which is comparable with that for the vertical core (30.9%). Finally, the effect of capillary number on stability of trapped gas bubbles has been estimated. Trapped gas bubbles are stable against the increased flow rate up to a capillary number of 1.0×10−5.