Integrated control of solidification microstructure and melt pool dimensions in electron beam wire feed additive manufacturing of Ti-6Al-4V

The ability to deposit a consistent and predictable solidification microstructure can greatly accelerate additive manufacturing (AM) process qualification. Process mapping is an approach that represents process outcomes in terms of process variables. In this work, a solidification microstructure process map was developed using finite element analysis for deposition of single beads of Ti-6Al-4V via electron beam wire feed AM processes. Process variable combinations yielding constant beta grain size and morphology were identified. Comparison with a previously developed process map for melt pool geometry shows that maintaining a constant melt pool cross sectional area will also yield a constant grain size. Additionally, the grain morphology boundaries are similar to curves of constant melt pool aspect ratio. Experimental results support the numerical predictions and identify a proportional size scaling between beta grain widths and melt pool widths. Results further demonstrate that in situ indirect control of solidification microstructure is possible through direct melt pool dimension control.