A new electrical configuration for improving the range of piezoelectric bimorph benders

• Similar components required when compared to traditional configuration.
• Uses one bias source and one controlled voltage source.
• Uses both the positive and negative electric fields to drive the piezoelectric.
• Significantly improved deflection and force of piezoelectric benders.

This article describes a new electrical configuration for driving piezoelectric benders. The ‘Biased Bipolar’ configuration is compatible with parallel-polled, bimorph and multimorph benders. The new configuration is similar to the standard three-wire drive method where the top electrode is biased with a DC voltage and the bottom electrode is grounded. However, the new configuration uses an alternate DC bias voltage and adjusted range for the central electrode which allows the full range of positive and negative electric fields to be utilized. Using this technique, the predicted deflection and force can be increased by a factor of 2.2 compared to the standard two wire configuration and 1.3 times for the standard three wire configuration. These predictions were verified experimentally where the measured factor of improvement in displacement and force was of 2.4 and 1.3 compared to the standard two-wire and three-wire configurations.