Investigation of a novel hybrid process of laser drilling assisted with jet electrochemical machining

Recast layer and spatter are two inherent defects commonly associated with holes produced with laser drilling. This paper reports a novel hybrid process of laser drilling assisted with jet electrochemical machining (JECM-LD) that aims to minimize such defects and improve the quality of laser-drilled holes. The process based on the application of a jet electrolyte, being aligned coaxially with the focused laser beam, on the workpiece surface during laser drilling. The effect of the jet electrolyte mainly is an electrochemical reaction with materials. The jet electrolyte also cools the workpiece and transports debris during the process. On the basis of a measurement of laser attenuation in electrolyte, an experimental apparatus system is made and JECM-LD experiments have been performed on 0.5-mm-thick 321S20 stainless steel with two lasers at wavelength of 1064 and 532 nm. It is shown that recast layer and spatter have been effectively reduced during the JECM-LD compared with laser drilling in ambient atmosphere conditions.