Broadband noise reduction by circular multi-cavity mufflers operating in multimodal propagation conditions

In this study, sound propagation through a circular duct with non-locally lining is investigated both numerically and experimentally. The liner concept is based on perforated screens backed by air cavities. Dimensions of the cavity are chosen to be of the order or bigger than the wavelength so acoustic waves within the liner can propagate parallel to the duct surface. This gives rise to complex scattering mechanisms among duct modes which renders the muffler more effective over a broader frequency range. This work emanates from the Cleansky European HEXENOR project which aim is to identify the best multi-cavity muffler configuration for reduction of exhaust noise from helicopter turboshaft engines. Here, design parameters are the cavity dimensions in both longitudinal and azimuthal directions. The best cavity configuration must in addition fit weight specifications which implies that the number of walls separating each cavity should be chosen as small as possible. To achieve these objectives, the scattering matrix of the lined duct section is obtained experimentally for two specific muffler configurations operating in multimodal propagation conditions. The good agreement with numerical predictions serves to validate the perforate plate impedance model used in our calculation. Finally, given an incident acoustic pressure which is representative of typical combustion noise spectrum, the best cavity configuration achieving the maximum overall acoustic Transmission Loss is selected numerically. The study also illustrates how the acoustic performances are dependent on the nature of the incident field.