The effect of mode ratio and bond interface on the fatigue behavior of a highly-toughened epoxy

The fatigue threshold and the cyclic crack growth of a highly-toughened epoxy adhesive were studied under mode I and several mixed-mode loading cases and compared with the quasi-static critical fracture energies. Four different adhesive systems were examined using steel and aluminum substrates having different surface roughness, and surface treatment. The effect of increasing the amount of mode II (increasing the phase angle) on the fatigue threshold strain energy release rate and the cyclic crack growth rate was found to be insignificant at low phase angles. However, a significant increase in the fatigue threshold and decrease in the cyclic crack growth rate was observed at higher phase angles. These trends were similar to that seen in adhesive joint fracture. Adherend surface roughness and surface preparation affected the fatigue behavior significantly, particularly at low crack speeds and high phase angles. The fatigue properties were essentially the same for both steel and aluminum adherends provided that the crack paths were cohesive. A general observation was that the fatigue crack path moved progressively closer to the more highly strained adherend under mixed-mode loading as the applied strain energy release rate and hence the crack speed, decreased. This caused mixed-mode cracks to be nearly interfacial in the threshold region.