Dynamic behavior of selected ceramic powders

An experimental setup has been developed on the continuous recording of the stress profiles in ceramic powders subject to shock loading with manganin gauges. A series of plate impact experiments on highly porous ceramic powders such as Al2O3, SiC and B4C were conducted at the laboratory's single stage powder gun facility. The relationship between shock wave velocity and particle velocity was measured to obtain the Hugoniot data. Plate impact onto powder sample experiments were conducted at loading stresses ranging from 1.6 to 4.2 GPa. The experimental results show that the shock wave speeds in various ceramic powders vary between 1 and 2 km/s. Linear Hugoniot relations between shock velocity (D) and particle velocity (u) are observed. The loading stress–specific volume form of Hugoniot relations (P–V) was constructed using the data from quasistatic compression test results, Hopkinson bar dynamic compression test results and powder gun plate impact experiment results. The P–V diagram shows that the crush strength of ceramic powders is comparable to the loading stress level. The B4C and SiC powders with bigger particle size more easily reach the solid state Hugoniot than the powders with smaller particle size at the same loading condition. In the case of Al2O3, the material shows less sensitivity to particle size difference at the same level of loading rate as compared to B4C and SiC.