Measurement and verification of position-independent geometric errors of a five-axis machine tool using a double ball-bar

• PIGEs of a five-axis machine tool are measured using a double ball-bar.
• Simple measurement paths are developed to decrease measurement cost.
• Set-up errors are investigated and minimized by using novel fixture.
• Measurement uncertainty of measured PIGEs is established for confidence interval.

In this study, position-independent geometric errors, including offset errors and squareness errors of rotary axes of a five-axis machine tool are measured using a double ball-bar and are verified through compensation. In addition, standard uncertainties of measurement results are calculated to establish their confidence intervals. This requires two measurement paths for each rotary axis, which are involving control of single rotary axis during measurement. So, the measurement paths simplify the measurement process, and reduce measurement cost including less operator effort and measurement time. Set-up errors, which are inevitable during the installation of the balls, are modeled as constants. Their effects on the measurement results are investigated to improve the accuracy of the measurement result. A novel fixture consisting of flexure hinges and two pairs of bolts is used to minimize set-up error by adjusting the ball's position located at the tool nose. Simulation is performed to check the validation of measurement and to analyze the standard uncertainties of the measurement results. Finally, the position-independent geometric errors of the five-axis machine tool (involving a rotary axis and a trunnion axis) are measured using proposed method.