Sub-nanosecond monitoring of micro-hole electrical discharge machining pulses and modeling of discharge ringing

Monitoring the gap voltage and current in micro-hole electrical discharge machining (EDM) using high-speed data acquisition with 0.5 ns sampling period is conducted. The spark and arc pulses at three stages, namely electrode dressing, drilling, and penetration, of the micro-hole EDM are recorded. The EDM process parameters are setup to use negative polarity to blunt the electrode tip and positive polarity for micro-hole drilling and penetration. A new phenomenon of pre-discharging current is discovered. In the first 20–30 ns of spark and arc pulses, the current starts to rise while the voltage remains the same. Effects of EDM process parameters, including the open voltage, electrode diameter, and polarity, on the rate of spark and arc pulses and electrode feed rate are investigated. A model based on the RLC circuit is developed to study the ringing effect at the end of a discharge. The intrinsic parasitic capacitance and resistance of a RLC circuit are calculated from the decaying voltage signal and compared under two sets of experiments with varying wire electrode diameter and gap voltage to validate the ringing model. The calculation and experimental results validate the proposed RLC model for ringing phenomenon. The model shows the electrode diameter has negligible effect on ringing and high open voltage increases the parasitic resistance and damping in ringing. The monitoring technique and ringing model developed in this research can assist in the selection and optimization of micro-hole EDM process parameters.