Evolution of subsequent yield surfaces and elastic constants with finite plastic deformation. Part III: Yield surface in tension–tension stress space (Al 6061–T 6511 and annealed 1100 Al)

Subsequent yield surfaces for aluminum alloys are determined for three proportional loading paths (i.e., axial, hoop, and combined hoop and axial stress) using 10 με deviation from linearity as the definition of yield. This paper is in continuation with Parts I and II of the author’s previous papers on subsequent yield surfaces under tension–torsion (σ11–√3σ12) stress space using similar small offset definition of yield. In the current paper comprehensive experimental results on subsequent yield surfaces under tension–tension (σ11–σ22) stress space are presented. Comparison of subsequent yield surfaces under (σ11–√3σ12) stress space, investigated in the earlier papers, clearly indicated distinctive hardening behavior under various loading paths. However, subsequent yield surfaces for Al 6061–T 6511 (a low work hardening alloy) showed contraction and negative cross-effect with finite deformation as compared to the annealed 1100 Al (a high work hardening alloy) where expansion and positive cross-effect was observed.