کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
787472 | 1465675 | 2009 | 20 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Computational modelling of dissipative open-cell cellular solids at finite deformations Computational modelling of dissipative open-cell cellular solids at finite deformations](/preview/png/787472.png)
This study concerns the constitutive modelling of dissipative open-cell structural cellular solids under primarily finite compressive deformations and the corresponding non-linear finite element implementation. A thermodynamically consistent, mechanistic approach presented in Hård af Segerstad et al. [Hård af Segerstad, P., Larsson, R., Toll, S., 2008. A constitutive equation for open-cell cellular solids, including viscoplasticity, damage and deformation induced anisotropy. International Journal of Plasticity. 24, 896–914.] is adopted for modelling the initial linear-elastic response and the subsequent plateau behaviour. In these regions the cellular solid is considered as a network of struts, where each strut connects two vertex points. A hypothesis is proposed that the vertex points move affinely in the finite strain regime, where the struts buckle plastically. The strut deformation is further assumed to be one-dimensional and depend directly on the macroscopic deformation; thus the description of the strut response requires only a scalar valued response function. Owing to this simple ansatz, the introduction of multiple non-linear mechanisms, such as hyperelasto-viscoplasticity and damage becomes feasible for large scale computations. An additional hyperelastic volumetric response, activated near the point-of-compaction, is introduced for two reasons, (i) to capture the stiffness recovery at high compressive volumetric deformations, where the struts come into contact, and (ii) to prevent numerical instability. The model is implemented as a user defined constitutive driver in the implicit version of the finite element code ABAQUS and tested experimentally for an open-cell aluminium alloy foam (Duocel 6101-0, 40 ppi). All material parameters are determined by a simple compression test, and subsequently used to simulate the indentation of a rigid sphere into a foam cylinder. The model accurately captures the experimental load–displacement relation and the deformed geometry.
Journal: International Journal of Plasticity - Volume 25, Issue 5, May 2009, Pages 802–821