A model of a reinforced tyre with a rod protector

A tyre design consisting of a steel-cord-reinforced rigid bond with sides connected to the wheel disc and a protector(tread) in contact with the road is examined. The tread is in the form of a set of rods connected by one end to the band, with the other end either free or in contact with the road. The rod end in contact with the road is acted upon by a force applied from the road, represented by a force normal to the road plane and a shear force due to dry friction. If the modulus of the shear force does not exceed the magnitude of the normal force multiplied by the dry friction coefficient, there is no slip at the contact point. In the opposite case, the rod end will be displaced along the road by an amount sufficient to distribute the normal and shear forces. The dynamics of longitudinal and transverse strains of the rods in contact with the road is analysed using the motion separation method in the quasi-static approximation. The behaviour of the tread rods as a function of the vertical displacement of the wheel centre is investigated, the contact area is found and the conditions are determined under which the contact area is divided into parts in which either slip of the rod ends occurs or does not occur, depending on the magnitude of the longitudinal displacement of the wheel centre or its turning relative to the horizontal axis. An analogue of a continuous model of a rod-like tread is considered, and the magnitudes of the forces and moments are found as a function of the wheel disc displacements. The equations of wheel rolling are obtained, and the conditions under which steady motions exist are found.