کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
796592 | 1466790 | 2006 | 8 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Working range for sequences and series of two-symmetrical grooves in wire rod rolling Working range for sequences and series of two-symmetrical grooves in wire rod rolling](/preview/png/796592.png)
A calculation procedure has been developed to determine the working range for series of grooves including “oval”, “round”, “false round”, “square” and “diamond” shapes. The minimum and maximum roll-gap setting and corresponding bar areas are calculated for all grooves. Flatter ovals increase the flexibility in false round–oval series and low rolling geometry factors reduce the working range. The working range is smaller for pass sequences designed for high reductions. To evaluate the model, laboratory tests for passes in “round”–“oval”–“false round”–“oval” sequences were carried out. Samples from a square–oval series were examined and it was shown that this series was insufficient for stainless steel wire rod rolling. The fitting factors were too high and the square grooves were slightly overfilled. It is shown that “false round”–“oval” series give the largest working range and thus enable the rolling of a wide range of different stainless steel grades.
Journal: Journal of Materials Processing Technology - Volume 174, Issues 1–3, 25 May 2006, Pages 250–257