Parametric study of the creep failure of double lap adhesively bonded joints

• Developing rheological based constitutive equation to model adhesive creep behavior.
• Investigating and simulating creep behavior of double lap adhesively bonded joints.
• Increasing double lap joint creep life time by applying adhesive fillet.
• Adhesive thickness has insignificant effect on bonded joint creep lifetime.

In this paper the influence of adhesive thickness and adhesive fillet on the creep deformation and creep life time of the adhesively bonded double lap joint have been studied experimentally. Also finite element modeling was used to simulate creep behavior of bonded joints and the results are compared with those obtained from experimental tests. The adhesive used in this research was Araldite 2015 which is an epoxy based adhesive. Research procedure is carried out in two major stages. Firstly, uniaxial creep tests were conducted in 63 °C to obtain the creep characteristics and constitutive equation parameters of the adhesive at 63 °C. An empirical based rheological model based on Maxwell and Zener’s model is proposed to simulate the creep behavior of the adhesive and it is used to predict the creep behavior of the bonded joint using finite element method. Numerical results show good agreement with experimental data. It was observed that applying fillet increases creep life and decreases joint creep deformation, however increasing adhesive thickness has slight effect on the creep life time of the joint.