On the failure of low carbon steel resistance spot welds in quasi-static tensile–shear loading

Failure behavior of low carbon steel resistance spot welds in quasi-static tensile–shear test is investigated. Microstructure, hardness profile and mechanical performance of the spot welds were studied. Results showed that spot welds are failed in two distinct failure modes: double-pullout and interfacial failure modes. There is a critical fusion zone size beyond which, pullout failure mode is guaranteed. Metallographic examination showed that failure is a competitive process between shear plastic deformation of weld nugget and necking of the base metal. In pullout failure mode, only the grain pattern of the base metal changes significantly and that of the fusion zone and heat affected zone remains unchanged. Strain localization was occurred in the base metal due to its low hardness. Moreover, the experimental results showed that increasing the holding time which increases the hardness of the fusion zone did not affect the peak load. It was concluded that in the pullout failure mode, the strength of the spot welds is not affected by the fusion zone strength. Fusion zone size proved to be the most important controlling factor for the spot welds’ mechanical performance in terms of peak load and energy absorption.