کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
832183 | 908117 | 2010 | 4 صفحه PDF | دانلود رایگان |
CNx–TiNx composite films were prepared on high-speed steel (HSS) substrate by pulsed KrF excimer laser co-deposition process with graphite/Ti combined targets and a substrate temperature of 200 °C. The composition, morphology and microstructure of the films were characterized by energy dispersive X-ray spectrum (EDS), scanning electron microscopy (SEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and high-resolution transmission electron microscopy (HRTEM). The adhesion and tribological performance of the films were investigated using a conventional scratch tester and a ball-on-disk tribometer, respectively. In the graphite/Ti range of 0.5–2.0 of the target, TiNx, a-CNx and metallic Ti phase were found in the composite films. The TiNx disappeared in the films at a high graphite/Ti ratio of the target. With increasing the graphite/Ti ratio of the target, the adhesion to substrate of the composite films deteriorated from 46 N to 26 N, and the friction coefficient decreased from 0.23 to 0.17. The composite film deposited at the graphite/Ti ratio of 1.0 showed a low friction coefficient, good adhesion and wear rate of 3.2 × 10−7 mm3/Nm in humid air.
Journal: Materials & Design - Volume 31, Issue 4, April 2010, Pages 1716–1719