کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
9679338 | 1455080 | 2005 | 8 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Wear mechanisms of WC inserts in face milling of gamma titanium aluminides
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی شیمی
شیمی کلوئیدی و سطحی
پیش نمایش صفحه اول مقاله
چکیده انگلیسی
This paper presents a new experimental investigation of the wear mechanisms of coarse and fine WC grain inserts during face milling of the γ-TiAl alloy, Ti-47Al-2Nb-2Mn (at.%) + 0.8 vol% TiB2. Tool wear was evaluated under the following cutting conditions: cutting speeds ranged from 20 to 300 m/min, the feeds ranged from 0.05 to 0.2 mm/tooth, the axial and radial depth of cut were constant and equal to 1 and 30 mm, respectively. Under these conditions, it was found that abrasion, adhesion and fatigue were the wear mechanisms controlling the deterioration and final failure of the WC inserts. Furthermore, inserts with fine WC grain size (<1 μm) and 10% Co content wore down at a lower rate than those with coarse WC grain size. Parallel to tool wear evaluation, the machinability of this γ-TiAl alloy was assessed in terms of tool life, chip formation, cutting forces and surface integrity. The analysis of chip microhardness and cutting forces demonstrated that this alloy had marked strain rate sensitivity and tendency to strain hardening when face milled under the specified cutting conditions.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Wear - Volume 259, Issues 7â12, JulyâAugust 2005, Pages 1160-1167
Journal: Wear - Volume 259, Issues 7â12, JulyâAugust 2005, Pages 1160-1167
نویسندگان
R.G. Vargas Pérez,