Effects of electron-beam irradiation on wettability and surface free energy of a polypropylene film

Effect of the electron radiation generated by a high-voltage linear accelerator on the wettability, contact angle and surface free energy (SFE) of a biaxially oriented polypropylene (BOPP) film was studied. Radiation doses of 25, 50, 100, 250, and 500 kGy were used. Water, glycerol, formamide, diiodomethane, and α-bromonaphthalene were applied as measuring liquids. The calculations of SFE were made with the methods of Owens-Wendt and van Oss-Chaudhury-Good, using the results of measurements of the contact angle with various sets of the measuring liquids. Wettability tests were also performed. It was found that the contact angle decreased with the rising radiation dose for all the measuring liquids and the shapes of these dependences were similar to one another. However, significant quantitative differences were observed. The largest changes in the contact angle were detected in the dose range of up to 100 kGy. The SFE values when measured with different methods and various measuring liquids differed generally in the whole range of the applied doses. Therefore, the surface free energy cannot be accepted as an absolute measure of the thermodynamic state of the surface layer of a radiation-modified BOPP film. Its values can be compared with one another only when they were determined with the same method and same measuring or standard liquids.