کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
9707603 | 1466161 | 2005 | 7 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Finite element evaluation of punch-type crack specimens
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
سایر رشته های مهندسی
مهندسی مکانیک
پیش نمایش صفحه اول مقاله

چکیده انگلیسی
The single punch shear (SPS) and double punch shear (DPS) specimens have been used in the past for determining Mode II fracture toughness of engineering materials. These two specimens are studied in this paper using a set of linear elastic finite element analysis. The near-crack-tip parameters consisting of stress intensity factors and T-stress are calculated in terms of the crack length ratio a/W for each specimen. It is shown that none of the specimens are subjected to pure Mode II since a considerable value of KI/KII is present for punch-type loading. The T-stress is also negative for both specimens. Using a generalized maximum tangential stress criterion, possible effects from ignoring the contributions of KI and T are investigated for test results obtained from these specimens when the failure is due to brittle fracture.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Pressure Vessels and Piping - Volume 82, Issue 9, September 2005, Pages 722-728
Journal: International Journal of Pressure Vessels and Piping - Volume 82, Issue 9, September 2005, Pages 722-728
نویسندگان
M.R. Ayatollahi, A. Asadkarami, Mahnaz Zakeri,