Keywords: Dual-induction LWD; 3D finite element method; Tool structure; Skin effect; Environment correction;
مقالات ISI (ترجمه نشده)
مقالات زیر هنوز به فارسی ترجمه نشده اند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
Keywords: Composite resin inlay; Direct composite restoration; Polymerization shrinkage; Stress in molar teeth; Modified von Mises failure criterion; Contact stresses at the cement–tooth adhesive interface; 3D finite element method
Mechanical behavior of two kinds of prestressed composite linings: A case study of the Yellow River Crossing Tunnel in China
Keywords: Shield tunnel; 3D finite element method; Prestressed composite lining; Water conveyance; Yellow River Crossing Tunnel;
Grain refinement of Mg-Al alloys by optimization of process parameters based on three-dimensional finite element modeling of roll casting
Keywords: magnesium alloy; roll casting; process parameter; 3D finite element method; thermal-stress;
Effect of protein denaturation degree on texture and water state of cooked meat
Keywords: Protein denaturation; Meat; Distribution; Kinetic; 3D finite element method; Elastic modulus; MRI
The influence of ferrule effect and length of cast and FRC posts on the stresses in anterior teeth
Keywords: Ferrule effect; Cast and FRC post and core; Length of post; Modified von Mises failure criterion; Contact stresses at the cement–tooth adhesive interface; 3D finite element method; Stresses in anterior teeth
Modelling of the lock-in thermography process through finite element method for estimating the rail squat defects
Keywords: Lock-in thermography; Phase contrast; Non-destructive inspection; 3D finite element method
Three-dimensional finite element analysis of molars with thin-walled prosthetic crowns made of various materials
Keywords: Zirconia crowns; Leucite-reinforced ceramic crowns; Gold alloy crowns; Resin composite crowns; Strength of molars; 3D finite element method; Simulation of mastication; Contact stresses at a cement–tooth adhesive interface; Modified von Mises failure crite
Three-dimensional analysis of bearing behavior of piled raft on soft clay
Keywords: Piled raft; Soft clay; 3D finite element method; Slip interface; Load sharing; Factor of safety
γ′/γ″ Co-precipitation in Inconel 706 alloy: A 3D finite element study
Keywords: 3D finite element method; Misfit; Coarsening; Interface; Ni–Fe based superalloy
Transient stability analysis of large aluminum stabilized superconductor by 3D finite element method
Keywords: Transient stability analysis; Aluminum stabilized superconductor; 3D finite element method;