The effect of manipulation of silk scaffold fabrication parameters on matrix performance in a murine model of bladder augmentation

Autologous gastrointestinal segments are utilized as the primary option for bladder reconstructive procedures despite their inherent morbidity and significant complication rate. Multi-laminate biomaterials derived from Bombyx mori silk fibroin and prepared from a gel spinning process may serve as a superior alternative for bladder tissue engineering due to their robust mechanical properties, biocompatibility, and processing plasticity. In the present study, we sought to determine the impact of variations in winding (axial slew rate: 2 and 40 mm/s) and post-winding (methanol and lyophilization) fabrication parameters on the in vivo performance of gel spun silk scaffolds in a murine model of bladder augmentation. Three silk matrix groups with distinct structural and mechanical properties were investigated following 10 weeks of implantation including our original prototype previously shown to support bladder regeneration, Group 1 (2 mm/s, methanol) as well as Group 2 (40 mm/s, methanol) and Group 3 (40 mm/s, lyophilization) configurations. Non surgical animals were assessed in parallel as controls. Quantification of residual scaffold area demonstrated that while Group 1 and 2 scaffolds were largely intact, processing parameters utilized for Group 3 led to significantly higher degrees of scaffold degradation in comparison to Group 1. Histological (hematoxylin and eosin, masson's trichrome) and immunohistochemical (IHC) analyses showed comparable extents of smooth muscle regeneration and contractile protein (α-smooth muscle actin and SM22α) expression within the original defect site throughout all matrix groups similar to controls. Parallel evaluations demonstrated transitional urothelial formation with prominent uroplakin and p63 protein expression supported by Group 1 and 3 scaffolds, while Group 2 variants supported a thin, immature epithelium composed primarily of uroplakin-negative, p63-positive basal cells. Voided stain on paper analysis revealed similar voiding patterns between all matrix groups; however Group 2 animals displayed substantially lower voided volumes with increased frequency in comparison to controls. In addition, cystometric assessments revealed all matrix groups supported comparable degrees of bladder compliance similar to control levels. The results of this study demonstrate that selective alterations in winding and post-winding fabrication parameters can enhance the degradation rate of gel spun silk scaffolds in vivo while preserving their ability to support bladder tissue regeneration and function.