Film formation from monodisperse acrylic latices

The influence of drying temperature on the properties of latex films was investigated by gravimetry, turbidimetry (i.e., analysis of transmission spectra and interference), atomic force microscopy and measurement of water vapor permeability. Several pitfalls in the determination of water content of dried films that absorb water after being submerged in it have been proposed, such as fading boundaries, remaining water after drying and change of particle sizes. At moderately higher temperatures film formation is improved. This improvement follows from the formation of smoother film surfaces (AFM), lower water vapor permeabilities and smaller values for Δλmin. On the other hand, defects as cracks and channels also are created, especially at high temperatures. It appears, however, that these channels do not run from the one surface of a film to the other.