کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
10412304 | 894885 | 2005 | 6 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Manufacture of a nanotweezer using a length controlled CNT arm
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
موضوعات مرتبط
مهندسی و علوم پایه
شیمی
الکتروشیمی
پیش نمایش صفحه اول مقاله

چکیده انگلیسی
In this paper, we propose a new method to make a nanotweezer composed of two carbon nanotube (CNT) arms. We fabricated the CNT arm by attaching a multi-wall carbon nanotube on a tungsten-tip via manual assembly. The closing actuation of the nanotweezer is simulated and the simulation is compared with experimental results. Since each CNT arm has a macro actuator, namely a separated tweezer arm, it is possible to close and open the nanotweezer repeatedly. Electrochemical etching is used to cut the carbon nanotube in the CNT arm and the cutting resolution is approximately a few hundred nanometers.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Sensors and Actuators A: Physical - Volume 120, Issue 1, 29 April 2005, Pages 193-198
Journal: Sensors and Actuators A: Physical - Volume 120, Issue 1, 29 April 2005, Pages 193-198
نویسندگان
Junsok Lee, Soohyun Kim,