A practical structural health monitoring system for carbon fibre reinforced composite based on electrical resistance

A practical structural health monitoring system based on measuring changes in the electrical resistance of a carbon fibre composite structure is presented. Electrical contact with the fibres is provided by flexible printed circuit boards which are interleaved with the carbon fibre plies during the lamination of the composite. The resistance between opposite pairs of contacts was measured before and after an impact load which caused barely visible impact damage (BVID) in the panel. It was found that even low levels of impact damage produced measurable changes in resistance in the vicinity of the damage. Therefore was demonstrated that electrical resistance measurements are a practical means of locating BVID. Various parameters were studied in order to better understand the mechanisms involved and optimise the system for improved sensitivity and accuracy. The location of the contacts in the through thickness direction, the spacing and orientation of the contacts and the residual thermal stress of the laminate were all investigated and recommendations made. A structural health monitoring system for composites based on electrical resistance has several important potential benefits over acoustic, ultrasonic or optical methods; it adds little parasitic mass, causes no reduction in mechanical integrity, can be carried out on structures either in or out of service conditions and is very simple in concept, implementation and data interpretation.