کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
10673334 | 1010245 | 2015 | 4 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
High speed end milling of a zirconium alloy
ترجمه فارسی عنوان
پایان دادن به سرعت بالا پایان یک آلیاژ زیرکونیوم
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
یکپارچگی سطح، فرزکاری، زیرکونیوم،
موضوعات مرتبط
مهندسی و علوم پایه
سایر رشته های مهندسی
مهندسی صنعتی و تولید
چکیده انگلیسی
The paper details a comprehensive investigation into the machinability and surface integrity of Zircaloy-4 following end milling. Tool wear after machining for â¼30 min at a cutting speed of 320 m/min was low, with surface roughness (Ra) values typically <0.6 μm. No evidence of thermal damage was detected on any of the surface/subsurface cross-sections analysed, although adhesion/re-deposition and smeared material with a width of â¼50 μm was prevalent on the workpiece surface, particularly when operating at higher cutting speeds (320 m/min) and depths of cut (0.6 mm). Surface residual stresses were compressive up to a value of 120 MPa.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: CIRP Annals - Volume 64, Issue 1, 2015, Pages 105-108
Journal: CIRP Annals - Volume 64, Issue 1, 2015, Pages 105-108
نویسندگان
Richard Hood, Sein Leung Soo, Colin Sage, Phill Carcass,