New understandings of the seismic modes of high productivity wells in the Sinian Dengying Fm gas reservoirs in the Gaoshiti area, Sichuan Basin

The Sinian Dengying Fm in the Sichuan Basin is a set of fractured-vuggy reservoirs mainly dominated by sedimentation and karstification, and characterized by small fractures and vugs, complex stratigraphy and lithology, and strong vertical and lateral reservoir heterogeneity. As a result, the drilling rates are lower and single-well gas productivity varies greatly there. And the reservoir identification results based on seismic data in this area are ambiguous. In view of this, the Deng 4 Member in the Gaoshiti buried structure on the southern flank of the Leshan-Longnüsi palaeohigh was precisely divided in stratigraphy. Then, the types of reservoir assemblages were determined based on gas well logging and test data, and the seismic response characteristics of typical wells with different types of reservoir assemblages and the seismic modes of high productivity wells were studied by using high-resolution seismic data. It is indicated that the Deng 4 Member in this area is divided into three types of reservoir assemblages, which correspond to three seismic modes. Seismic mode I: It presents the seismic response characteristics of “wide wave troughs + double highlights” or “wide wave troughs + complex waves”, indicating that fractures and vugs are developed. It is the preferred seismic mode of high productivity wells in the stage of development. In this mode, the technology of highly deviated wells or horizontal wells can be implemented. Seismic mode II: It presents the seismic response characteristics of “wide wave troughs”, indicating that fractures and vugs are relatively developed. It is the mode of moderate productivity wells. In this mode, the technology of highly deviated wells can be implemented. Seismic mode III: It presents the seismic response characteristics of “wide wave troughs + highlights”, indicating that fractures and vugs are underdeveloped. It is mode of low productivity wells, in which the technology of horizontal wells can be implemented. The new understandings on seismic modes were applied on site. It is shown that the reservoir drilling rate is over 60% and the average gas production rate during the production test of 8 wells is up to 75.34 × 104 m3/d. It is concluded that the seismic mode of high productivity wells based on seismic facies, fracture and vug prediction and integrated target design provides a support for the well arrangement and drilling trajectory adjustment in natural gas exploration and development in the Gaoshiti area and good results have been achieved.